Plifold
← Papercraft

Harbor tugboat papercraft template

Make a harbor tugboat in folded cardstock. Start around the funnel and work down through the wheelhouse. The sloping bow should project above the waterline.

Finished size (W × H × D)
81 × 44 × 23 mm
Difficulty
Easy with careful scoring
Cardstock
160–200 gsm
Assembled harbor tugboat shown as a digital model.
Digital assembly view. The PDF includes plain face plates for your own finish.

Harbor tugboat papercraft template materials and scoring

Step by step

  1. Print the plates and bands. Choose A4 or US Letter, print both sheets at actual size and measure the 25 mm bar. Plate A is the front and B is its mirror. Cut both outer contours, leaving the numbered edge map intact.
  2. Prepare the numbered strips. The 2 strips form 15 wall panels. Score every dashed line while the sheet is flat, then cut the solid outline around each strip, keeping the two rows of tabs and the end flap. Edge 6 is the shortest at 8.0 mm. Pinch that crease against the ruler.
  3. Fit the front profile. Start around the funnel and work down through the wheelhouse. The sloping bow should project above the waterline. With the printed strip numbers facing inside, match panel 1 to edge 1 on the map. Glue one row of tabs to the inside of A, working around the numbered outline. Join the end flaps behind the next strip.
  4. Close the back. Use plate B to check the fit before adding glue. Fold the free row of tabs inward and attach B in short sections. Check that the finished piece is 23 mm deep at both ends. Add drawn details to the face if desired.

Planning the harbor tugboat build

The finished piece measures 81 mm across and 44 mm high when you look squarely at the front. The side wall adds 23 mm of depth. Stand the front vertically beside a sheet of squared paper. Use a long edge of the vehicle or building as a horizontal reference. Compare both ends of the back against that same line during the dry fit to catch a tilted roof or chassis early.

Allow about 35–55 minutes of hands-on work as a planning estimate, plus drying time for your glue. There are 15 numbered wall panels to bend. If you are new to cutting models, begin with the front and leave the side strips for a second sitting. Keep the edge map on the table between sessions so you can find your place again.

Reading the edge map and checking the fit

Choose the file that matches the paper loaded in your printer. Both editions give the same finished dimensions. If the scale bar is short, turn off fit-to-page and print again before cutting anything. For a colour finish, test a pencil or marker on the unused margin. Some markers bleed through card and can hide the scoring marks on the other side.

For this outline the bands cover edges 1–12, 13–15, in that order. Together they travel approximately 236 mm around one face. Separate the bands one at a time. Write their first and last numbers on scrap slips and lay the strips beside them. A slipped strip can look almost right until you reach a corner that bends the opposite way.

Edge 14, about 52.0 mm long, is a useful straight reference. Lay that panel against the matching line with no glue and hold both ends level. Then try edge 6, only 8.0 mm. If that corner springs open, deepen the score on the waste side of a test strip and try the same pressure on the real hinge.

Finishing the harbor tugboat and correcting a twisted seam

Mark the wheelhouse windows before drawing the waterline. Keep the bow distinct from the stern by holding the plate beside the numbered outline as you decorate.

Place the unglued back over the standing walls and sight along the long reference edge. If one end lifts, trace the numbers back to the last joint that sits flush. Check the band order and fold direction there before pressing the back down. Allow the adhesive to grab with both plates parallel. A control print and digital assembly view are available here. A learner build with paper is still pending.

Related projects

Lighthouse papercraft template →Gabled row house papercraft template →Compare 3D model constructions