Orchard pear papercraft template
Make a orchard pear in folded cardstock. Form the short stem first. Ease the band around the broad lower fruit and press the flattest edge last.
- Finished size (W × H × D)
- 54 × 62 × 21 mm
- Difficulty
- Easy with careful scoring
- Cardstock
- 160–200 gsm

Orchard pear papercraft template materials and scoring
- Two sheets of 160–200 gsm cardstock, scissors, a ruler, a blunt scoring tool and paper glue.
Step by step
- Print the plates and bands. Choose A4 or US Letter, print both sheets at actual size and measure the 25 mm bar. Plate A is the front and B is its mirror. Cut both outer contours, leaving the numbered edge map intact.
- Prepare the numbered strips. The 2 strips form 16 wall panels. Score every dashed line while the sheet is flat, then cut the solid outline around each strip, keeping the two rows of tabs and the end flap. Edge 6 is the shortest at 5.0 mm. Pinch that crease against the ruler.
- Fit the front profile. Form the short stem first. Ease the band around the broad lower fruit and press the flattest edge last. With the printed strip numbers facing inside, match panel 1 to edge 1 on the map. Glue one row of tabs to the inside of A, working around the numbered outline. Join the end flaps behind the next strip.
- Close the back. Use plate B to check the fit before adding glue. Fold the free row of tabs inward and attach B in short sections. Check that the finished piece is 21 mm deep at both ends. Add drawn details to the face if desired.
Planning the orchard pear build
The finished piece measures 54 mm across and 62 mm high when you look squarely at the front. The side wall adds 21 mm of depth. Try the silhouette against the background where it will be displayed. Turn the loose piece from side to side. If a thin projection disappears against your fingers, choose a broader section to hold while fitting the wall and decorating the front.
Allow about 40–60 minutes of hands-on work as a planning estimate, plus drying time for your glue. There are 16 numbered wall panels to bend. If you are new to cutting models, begin with the front and leave the side strips for a second sitting. Keep the edge map on the table between sessions so you can find your place again.
Reading the edge map and checking the fit
Choose the file that matches the paper loaded in your printer. Both editions give the same finished dimensions. If the scale bar is short, turn off fit-to-page and print again before cutting anything. For a colour finish, test a pencil or marker on the unused margin. Some markers bleed through card and can hide the scoring marks on the other side.
For this outline the bands cover edges 1–14, 15–16, in that order. Together they travel approximately 183 mm around one face. Separate the bands one at a time. Write their first and last numbers on scrap slips and lay the strips beside them. A slipped strip can look almost right until you reach a corner that bends the opposite way.
Edge 14, about 16.3 mm long, is a useful straight reference. Lay that panel against the matching line with no glue and hold both ends level. Then try edge 6, only 5.0 mm. If that corner springs open, deepen the score on the waste side of a test strip and try the same pressure on the real hinge.
Finishing the orchard pear and correcting a twisted seam
Start the shading at the widest part of the fruit and fade it near the neck. Reserve a darker colour for the short stem.
Place the unglued back over the standing walls and sight along the long reference edge. If one end lifts, trace the numbers back to the last joint that sits flush. Check the band order and fold direction there before pressing the back down. Allow the adhesive to grab with both plates parallel. A control print and digital assembly view are available here. A learner build with paper is still pending.