Papercraft airplane template
Make a 90 mm passenger jet for your desk from two sheets of cardstock. Follow the top and underside maps to match the swept wings and close the tail.
- Length × wingspan × depth
- 90 × 57 × 12 mm
- Difficulty
- Intermediate
- Cardstock
- 160–200 gsm

Papercraft airplane template materials and scoring
- Two sheets of 160–200 gsm cardstock, scissors, a ruler, a blunt scoring tool and paper glue.
Step by step
- Print the plates and bands. Choose A4 or US Letter, print both sheets at actual size and measure the 25 mm bar. Plate A is the front and B is its mirror. Cut both outer contours, leaving the numbered edge map intact.
- Prepare the numbered strips. The 3 strips form 24 wall panels. Score every dashed line while the sheet is flat, then cut the solid outline around each strip, keeping the two rows of tabs and the end flap. Edge 24 is the shortest at 3.0 mm. Pinch that crease against the ruler.
- Fit the front profile. Cut the swept wings and tail with each face plate. Dry-fit the numbered wall around both wing tips before closing the underside. With the printed strip numbers facing inside, match panel 1 to edge 1 on the map. Glue one row of tabs to the inside of A, working around the numbered outline. Join the end flaps behind the next strip.
- Close the back. Use plate B to check the fit before adding glue. Fold the free row of tabs inward and attach B in short sections. Check that the finished piece is 12 mm deep at both ends. Add drawn details to the face if desired.
Planning the passenger jet plane build
The passenger jet measures 90 mm from nose to tail, with a 57 mm wingspan and a 12 mm deep body. Set plate A flat on the table as the upper face. On the first sheet, the top map points the nose right. Turn the second sheet to the upright reading position for the underside map. Plate B now points left. Match panels 12 and 13 at this nose before pressing the tabs.
Allow about 50–70 minutes of hands-on work as a planning estimate, plus drying time for your glue. There are 24 numbered wall panels to bend. Keep the numbered maps beside the two plain cutouts. Set the upper plate down before curling the side strips.
Reading the edge map and checking the fit
Check the underside of the airplane
For this outline the bands cover edges 1–11, 12–22, 23–24, in that order. Together they travel approximately 327 mm around one face. Separate the bands one at a time. Write their first and last numbers on scrap slips and lay the strips beside them. A slipped strip can look almost right until you reach a corner that bends the opposite way.
Edge 16, about 35.5 mm long, is a useful straight reference. Lay that panel against the matching line with no glue and hold both ends level. Then try edge 24, only 3.0 mm. If that corner springs open, deepen the score on the waste side of a test strip and try the same pressure on the real hinge.
Finishing the passenger jet plane and correcting a twisted seam
Use the nose and the middle of the tail as two reference points for a light centre line on the upper face. Mark matching panels on the swept wings while both tips lie flat.
Place the unglued back over the standing walls and sight along the long reference edge. If one end lifts, trace the numbers back to the last joint that sits flush. Check the band order and fold direction there before pressing the back down. Allow the adhesive to grab with both plates parallel. A control print and digital assembly view are available here. A learner build with paper is still pending.