Humpback whale papercraft template
Make a humpback whale in folded cardstock. Leave the belly open while pressing the flipper tab. Check that the upturned tail sits above the back.
- Finished size (W × H × D)
- 93 × 44 × 22 mm
- Difficulty
- Intermediate
- Cardstock
- 160–200 gsm

Humpback whale papercraft template materials and scoring
- Two sheets of 160–200 gsm cardstock, scissors, a ruler, a blunt scoring tool and paper glue.
Step by step
- Print the plates and bands. Choose A4 or US Letter, print both sheets at actual size and measure the 25 mm bar. Plate A is the front and B is its mirror. Cut both outer contours, leaving the numbered edge map intact.
- Prepare the numbered strips. The 2 strips form 19 wall panels. Score every dashed line while the sheet is flat, then cut the solid outline around each strip, keeping the two rows of tabs and the end flap. Edge 7 is the shortest at 6.3 mm. Pinch that crease against the ruler.
- Fit the front profile. Leave the belly open while pressing the flipper tab. Check that the upturned tail sits above the back. With the printed strip numbers facing inside, match panel 1 to edge 1 on the map. Glue one row of tabs to the inside of A, working around the numbered outline. Join the end flaps behind the next strip.
- Close the back. Use plate B to check the fit before adding glue. Fold the free row of tabs inward and attach B in short sections. Check that the finished piece is 22 mm deep at both ends. Add drawn details to the face if desired.
Planning the humpback whale build
The finished piece measures 93 mm across and 44 mm high when you look squarely at the front. The side wall adds 22 mm of depth. Put the front and its mirrored back on opposite sides of the map. Follow the contour with a finger to find any narrow point that will be difficult to press from inside once the shell closes. Leave that area accessible while the first tabs set.
Allow about 40–60 minutes of hands-on work as a planning estimate, plus drying time for your glue. There are 19 numbered wall panels to bend. If you are new to cutting models, begin with the front and leave the side strips for a second sitting. Keep the edge map on the table between sessions so you can find your place again.
Reading the edge map and checking the fit
Choose the file that matches the paper loaded in your printer. Both editions give the same finished dimensions. If the scale bar is short, turn off fit-to-page and print again before cutting anything. For a colour finish, test a pencil or marker on the unused margin. Some markers bleed through card and can hide the scoring marks on the other side.
For this outline the bands cover edges 1–12, 13–19, in that order. Together they travel approximately 237 mm around one face. Separate the bands one at a time. Write their first and last numbers on scrap slips and lay the strips beside them. A slipped strip can look almost right until you reach a corner that bends the opposite way.
Edge 3, about 20.1 mm long, is a useful straight reference. Lay that panel against the matching line with no glue and hold both ends level. Then try edge 7, only 6.3 mm. If that corner springs open, deepen the score on the waste side of a test strip and try the same pressure on the real hinge.
Finishing the humpback whale and correcting a twisted seam
Test the division between the pale belly and dark back on the flat plate. Follow the body length and let the tail flukes keep their full silhouette.
Place the unglued back over the standing walls and sight along the long reference edge. If one end lifts, trace the numbers back to the last joint that sits flush. Check the band order and fold direction there before pressing the back down. Allow the adhesive to grab with both plates parallel. A control print and digital assembly view are available here. A learner build with paper is still pending.