Origami box with lid from two squares
Fold a square masu box with a fitted lid from two sheets. Compare three paper sizes, follow four steps, and check the fit at each corner.
What size paper makes the box you need?
A 15 cm square makes a tray about 5.3 cm wide and 2.7 cm deep. Choose thin folding paper with contrasting sides for your first box. Set the colour you want on the outside face down. You can cut a second square for a matching lid once you have tried the base.
| Starting square | Box width | Wall height |
|---|---|---|
| 120 mm | 42.4 mm | 21.2 mm |
| 150 mm | 53.0 mm | 26.5 mm |
| 200 mm | 70.7 mm | 35.4 mm |
Origami box instructions for the base
- Locate the centre. Fold the square in half edge to edge in each direction and reopen it. Bring all four corners exactly to the crossing. The four tips should just meet. You now have a smaller square, sitting on a point.
- Set the wall heights. Rotate the small square so its sides run horizontally and vertically. Fold the left and right edges to the centre line and reopen them. Repeat with the top and bottom edges. The four creases now outline a square floor half as wide as the small folded square.
After the four corners meet, crease the small square at its quarter marks. The shaded square is the floor. The band from the floor to the outer edge sets the wall height. - Stand two walls. Unfold the top and bottom corner flaps fully, leaving the left and right flaps folded toward the middle. Lift the left and right sides on the creases that border the floor. Hold them upright with your thumbs inside. The two long flaps still lie flat on the table.
- Lock the ends. At one open end, push the two short diagonal corners inward and lift the long flap around them. Bend the flap over the rim and press its triangle onto the floor. Its tip should reach the centre. Repeat at the other end. If the box rocks on the table, lift the flap on the high side and flatten the corner tucked beneath it.
Fit a lid to the finished base
For a base folded from a 150 mm square, try a 155 mm square of the same paper for the lid. Fold it by the same four steps. The calculated widths are 53.0 and 54.8 mm. That leaves about 0.9 mm per side before the layers of paper take up space.
Try the same 5 mm difference with a 120 mm base and a 125 mm lid, or a 200 mm base and a 205 mm lid. A 5 mm change in starting paper adds about 1.8 mm to the finished width at any of these sizes. Use the same weight for both sheets. A thicker lid uses more of that allowance at the corners.
Place the lid squarely over the base. It should slide on without bowing the side walls. If only one corner catches, open that flap and flatten the tucked layers. If all four sides grip, try a slightly larger lid sheet. Test the fit before adding a liner or decorating the rim. For a closed shape made with scissors and glue, print the blank cube net.