Three-hole pamphlet stitch
Bind one nested section of paper with a single thread. This stitch holds the field notes journal together and leaves both thread ends inside.
- Technique
- Single-section binding
- Hole spacing
- 40 mm on this spine
Materials and tools
- A 120 mm folded spine, two clips, a piercing mat, awl or needle, and about 35 cm of thread.
Step by step
- Pierce three aligned holes. Nest the folded leaves and clip them together. Open the centre over a piercing mat. Mark holes 1, 2 and 3 at 20, 60 and 100 mm from the top of the spine. Pierce outward through each mark.
- Go out at the centre, in at the top. From inside the book, take the thread out through hole 2. Leave a 6 cm tail inside. Return from the outside through hole 1.
- Cross the spine inside. Run down the inside past the centre and go out through hole 3. Return along the outside and enter hole 2 without piercing the existing thread.
- Tie across the long stitch. Leave the two ends on opposite sides of the long inside stitch. Pull parallel to the spine until snug, tie a square knot over that stitch and trim. Open and close the cover to check the tension.
The stitch in photographs



Frames from Marci Easterbrook’s three-hole pamphlet demonstration, University of New Mexico. Watch the demonstration · CC BY 4.0