
Paper snowflake template for a six-point cutout
Start with a 144 mm circle. Four folds put twelve layers under the scissors. Each cut through the marked wedge appears around the whole snowflake when you open it.
Build a winter mantel scene with a fir, a bell or a little house. A freestanding star can mark a place at the table.

Start with a 144 mm circle. Four folds put twelve layers under the scissors. Each cut through the marked wedge appears around the whole snowflake when you open it.

Make a winter fir tree in folded cardstock. Treat each branch tier as a separate turn. Fit the trunk before gluing the lower boughs.

Make a winter bell in folded cardstock. Fit the clapper at the lower edge before sealing the lip. Work the small top loop while the back is open.

Make a gingerbread house in folded cardstock. Close the short valley beside the chimney before the roof slope. Add icing details while the wall plates lie flat.

Make a five-point star in folded cardstock. Alternate outward tips and inward valleys. Keep the first tip open until the fifth arm lines up.

Make a hanging stocking in folded cardstock. Start at the cuff corners and work down the ankle. Seat the rounded toe before closing the heel.
Set the fir tree beside the gingerbread house for a small tabletop scene. For a hanging star, dry-fit the front and back first to find the top point. Secure a small thread loop inside the model before closing the back panel. Use the candle model as a paper ornament with no flame. Each pattern has matching A4 and US Letter downloads.
Cut six 100 mm squares from lightweight paper. Keep five aside and make one arm first. Fold the square diagonally twice. Set the triangle on its long edge. Cut three slits from the folded short edge parallel to the long edge, stopping just short of the opposite side so the frames stay attached.
Open the square. Bring the innermost pair of opposite tips together over a pencil and tape them into a loop. Turn the square over for the next pair. Alternate faces as you join the remaining pairs. Repeat for the other five arms. Join the six arms at their bases and tape neighbours together where the outer loops touch.
Use the University of the Highlands and Islands illustrated sheet (PDF) to check the slits and loops. For a flat window decoration, print the six-point snowflake cutting pattern.