Origami butterfly projects for cards and garlands
Make an accordion-folded paper butterfly with two squares and thread. Follow the pleat direction, join the wings and adjust them to suit a card or garland.
Make a two-square pleated butterfly
This beginner paper butterfly uses two pieces and a thread tie. The pleats give the upper wings a pointed outline and the lower wings a shorter, softer edge. Use thin paper that will hold an accordion crease. Start with a 12 cm square for the upper wings and a 9 cm square for the lower pair. A separate 18 cm length of thread makes the centre tie.
- Pleat the upper wings. Place the larger square as a diamond. Starting at the bottom point, turn up a band about 8 mm deep. Flip the paper and fold the next band back the other way. Continue with parallel folds toward the top point.
- Pleat the lower wings. Place the smaller square with a flat edge toward you. Accordion-fold upward, edge to edge. Hold the resulting straight-ended strip at its middle.
- Join the centres. Find each strip’s midpoint by touching its ends together lightly. Lay the strips side by side, with the pointed strip above the straight one, and line up their midpoints. Wrap thread around both centres and tie a double knot.
- Fan the wings. Spread each of the four bundles outward. Support the tied waist as you separate the layers. Shorten the thread ends for antennae or use a separate loop around the waist for a hanging butterfly.
Choose a flat or dimensional finish
For a card, attach just the tied centre and leave the pleats loose. For a garland, space the butterflies apart by at least the width of the largest open wings. If a wing springs closed, re-crease its pleats individually before retightening the thread. For a rigid display figure with a flat front and side walls, follow the printable butterfly model.