Plifold
← Junk journals

Two-hole ribbon tie journal binding

A removable ribbon holds nested pages together. Undo the bow to exchange a filled page for a blank one without cutting the binding.

Method
Binding methods
Main cut size
148 × 106 mm
Print size
A4 or US Letter at 100%
Measured pattern for two-hole ribbon tie journal binding, including the main piece and its matching insert.
Printable cutting and folding layout. The separate guide or insert is drawn at the same scale as the main piece.

Materials and tools

Step by step

  1. Match the holes Fold the cover and inner leaves together and clip their heads. Place the guide in the open fold. Pierce at 26 and 80 mm from the top, only as wide as the ribbon needs.
  2. Thread the ribbon From the middle spread feed one end out through each hole. Flatten the length lying inside the book, checking that the ribbon has no half twist.
  3. Tie outside Bring both ends toward the midpoint of the outer spine and tie a small bow. Leave enough slack for the cover to open. Undo the bow once to practise changing the innermost leaf.

Check the finished piece

The inside ribbon should sit along the crease. If a hole puckers, loosen the bow and smooth the ribbon flat before tightening again.

This pattern has a digital scale drawing. An independent paper build is pending.

Related projects

Coptic stitch binding with one needleFive-hole pamphlet stitch for a junk journalSingle-sheet eight-page junk journal zine