Plifold
← Junk journals

Japanese stab binding with four holes

Make a pocket-size notebook from loose journal pages. Sew four wraps along the spine and one around each end, then open the cover along a scored hinge.

Method
Binding methods
Main cut size
90 × 124 mm
Print size
A4 or US Letter at 100%
Measured pattern for japanese stab binding with four holes, including the main piece and its matching insert.
Printable cutting and folding layout. The separate guide or insert is drawn at the same scale as the main piece.

Materials and tools

Step by step

  1. Prepare the covers and pierce four holes. Print at actual size and measure the 25 mm bar. Score the front cover at the dashed line 17 mm from the spine. Sandwich the leaves between the covers. With the spine on your left and the head at the top, line up the guide and clip it in place. Rest the stack on a piercing mat. Pierce holes 1 to 4 in order, then remove the guide.
  2. Start at 2 and wrap the top corner at 1. Pass the needle from back to front at 2. Leave 6 cm of thread on the back. Take the needle around the spine and enter 2 from the back again. Travel up the front to 1 and pass through to the back. Wrap the spine and enter 1 from the front. Wrap the top edge and enter 1 from the front once more. Your needle is now on the back.
  3. Sew through 2 and wrap the spine at 3. Run down the back from 1 to 2 and pass through to the front. Run down the front to 3 and pass through to the back. Take the thread around the spine and enter 3 from the front again. Hold the thread near each new wrap while easing out slack.
  4. Wrap the bottom corner at 4 and close at 2. Travel on the back to 4 and pass through to the front. Wrap the spine and enter 4 from the back. Wrap the bottom edge and enter 4 from the back once more. Travel up the front to 3 and pass through to the back. Run along the back to the loose tail at 2 and tie a square knot there. Tuck the ends under a neighbouring stitch.

Check the finished piece

On each face, trace three straight runs joining 1 to 2, 2 to 3 and 3 to 4. Check for four spine wraps and one wrap across each end. Open the cover at the score. If the holes pucker, ease the thread before tightening the knot.

This pattern has a digital scale drawing. An independent paper build is pending.

Check the thread on both covers

Front 1234 Back 1234
Hold the head at the top as you turn the book over. The bound edge is on the left of the front cover and the right of the back cover. The two short ends meet at hole 2 on the back.

Japanese stab binding in photographs

Thread passes around the spine and the needle re-enters the same hole.
Wrap the thread around the bound edge and return through the same hole.
A needle enters the corner station beside the short end wrap on a blue cover.
At the head and foot, the same hole takes a second wrap around the end.
A hand holds the blue sewn book while scissors trim the working thread.
The finished binding has a straight run between each pair of holes.

Photographs show the National Diet Library’s traditional pouch-bound sample. This Plifold project uses loose sheets and ties the ends on the back cover. Images adapted from the Preservation Division’s 2017 workshop, photographs 4, 9 and 17. Japanese Four-Hole Book Binding, pp. 5–7 · Image use

Related projects

Coptic stitch binding with one needleFive-hole pamphlet stitch for a junk journalSingle-sheet eight-page junk journal zine