Printable origami square base instructions
This is the printable version of a Plifold animated lesson. Each picture shows the paper after that step; red is the paper the step moved.
- You need
- One unfolded square sheet (a different colour on each side is best).
- Start position
- Light side up, one corner pointing at you, like a diamond.
- Finished
- A small diamond pointing up, with all four corners of the sheet gathered at the bottom point and two flaps on each side.
-
Step 1 Fold the left corner to the right corner
- What to hold
- Pick up the left half of the sheet by its left corner.
- Where it goes
- Lay the left corner exactly on the right corner and crease from the middle outwards, up and down.
- Check
- You have an upright triangle with its straight edge on the left.
- Watch out
- Make the left and right corners meet exactly before you crease.
-
Step 2 Unfold
- What to hold
- Lift the half you just folded over.
- Where it goes
- Open it back out to the left.
- Check
- The sheet is a whole diamond again, with a vertical crease down the middle.
- Watch out
- Only unfold; don't turn the paper over.
-
Step 3 Fold the bottom corner to the top corner
- What to hold
- Pick up the bottom half of the sheet by its bottom corner.
- Where it goes
- Lay the bottom corner on the top corner and crease.
- Check
- You have a triangle pointing up with its long edge at the bottom.
- Watch out
- The top and bottom corners should meet, and the two halves of the vertical crease should line up.
-
Step 4 Unfold
- What to hold
- Lift the half you just folded up.
- Where it goes
- Open it back down.
- Check
- The diamond has two diagonal creases, one across and one up and down, crossing in the middle.
- Watch out
- Only unfold; don't turn the paper over.
-
Step 5 Turn over
- What to hold
- Hold the left and right corners.
- Where it goes
- Turn it over from left to right and lay it flat again.
- Check
- Now the dark side is up, still with one corner pointing at you.
- Watch out
- Turn it left to right; afterwards a corner still points at you.
-
Step 6 Fold the upper left edge to the lower right edge
- What to hold
- Pick up the upper left half by its left corner.
- Where it goes
- Lay the left corner on the bottom corner so the upper left edge lies on the lower right edge, then crease.
- Check
- You have a slanted rectangle (like a closed book), with the folded edge running from lower left to upper right.
- Watch out
- This crease joins the midpoints of two edges and passes through no corner; the result is a rectangle, not a triangle.
-
Step 7 Unfold
- What to hold
- Lift the half on top.
- Where it goes
- Open it back where it was.
- Check
- The diamond now has a slanted crease from lower left to upper right as well.
- Watch out
- Only unfold; don't turn the paper over.
-
Step 8 Fold the upper right edge to the lower left edge
- What to hold
- Pick up the upper right half by its right corner.
- Where it goes
- Lay the right corner on the bottom corner and crease.
- Check
- You have a slanted rectangle, with the folded edge running from upper left to lower right.
- Watch out
- Again it joins only the midpoints of two edges; the result is a rectangle, not a triangle.
-
Step 9 Unfold
- What to hold
- Lift the half on top.
- Where it goes
- Open it back where it was.
- Check
- Four creases cross in the middle, like the spokes of a star.
- Watch out
- Only unfold; don't turn the paper over.
-
Step 10 Collapse into a small diamond
- What to hold
- Hold down the bottom section (marked “Hold still” in the picture) and fold the rest up together.
- Where it goes
- The two slanted creases fold up and the horizontal one folds down: bring the left, right and top corners all down onto the bottom corner, then press flat.
- Hand by hand
- With one hand, hold down the bottom section (either side of the lower half of the vertical crease); it stays flat throughout.
- With the other hand, take the left and right corners and raise them up and inwards along the two slanted creases.
- Push the top corner down along the horizontal crease; the left and right sections fold into the middle with it.
- Line the left, right and top corners up on the bottom corner, then press flat.
- Check
- You have a small diamond pointing up, with all four corners at the bottom point: one flap at the front, one at the back, and one tucked inside each side.
- Watch out
- If it won't collapse, a crease is usually going the wrong way: the slanted creases should rise towards you and the horizontal one should sink away.
Ready to try · not yet tested by learners with real paper