Plifoldblank-paper lessons
All lessonsReady to try · not yet tested by learners with real paper
2D front view · left and right as in the lessonDrag to move; switch to 3D to see paper lift.

Edge of the moving flapCorner pathThin line: other corners moving at the same timeFold along this lineGuide crease still visibleShades only tell flaps apart; real paper is one colour
Fold the classic crane from a blank square sheet: square base, bird base, narrowing, reverse folds for the neck, tail and head, then spread the wingsUse the 2D front view to line up corners and the 3D view to see raised layers. A red edge marks the moving flap and a dotted arc the path its corner takes.
Progress of this move0%
100%

Fold an origami crane step by step in 3D

One square sheet, two colours is bestAbout 20–30 min
Printable origami crane instructions Paper, size and folding tips

What to hold
Where it goes
Check

Watch out

This is what you will makeNeck and tail angle upwards, the head bows forward, and the two wings spread out to the sides.
The finished CraneA preview of the finished Crane, drawn from the lesson’s final folded geometry.

How to fold an origami crane

Choose a square you can read

Set aside 20–30 minutes and start with a 15 × 15 cm square. Thin, two-colour origami paper makes the petal folds easier to read. For a first attempt, try kami around 60–80 gsm. One coloured face and one white face show when a layer has turned over. If your paper is thick or your fingers crowd the centre, move up to a 20 cm square. Trim a rectangular sheet to a true square first. Even a slight mismatch at the opening diagonals travels all the way to the beak.

Find three places to pause

This is an intermediate fold. At step 10 you have a square base. Hold it by the closed point and check that the loose corners hang together. By step 25, opening and flattening each petal has turned it into a bird base, a long diamond with two separate narrow legs. Check both sides before thinning them. At step 39, the bent tip distinguishes the head from the tail. Only then lower the broad wings. These pauses make it easier to find the first misplaced layer without starting over.

Read the movement in 2D and 3D

Use the 2D view to match a corner to the centre crease. Pause the animation, move the progress slider back a little and watch the coloured area change sides. Switch to 3D when the paper leaves the table. Rotate the model slightly during the inside reverse folds at steps 33 and 36. Look for the gap where the point slips between two layers. Put your paper down in the same orientation before pressing Next. The printable instructions keep the picture and the hand movements together if you prefer to work away from the screen.

When the paper catches

If the diamond tears while you lift its flap, undo the lift and reopen the three preparatory creases. Let the side edges swing inward on those lines; the flap should rise without a tug. A blunt beak often starts with two layers pinched as one. Open the neck just enough to turn its small tip inside, then close it again. If one wing sits higher, compare the two wing-root creases with the body held from below. Pulling the tips to even them out can tear the back.

Set the wings and measure the bird

Cup the body between finger and thumb while easing the wings apart. With a 15 cm starting square, the final digital pose spans about 10 cm across the wings. The opening angle changes that distance. Set your finished bird on a table and measure straight from one wingtip to the other before choosing a display box. In Hiroshima, people send folded cranes to the Children’s Peace Monument in memory of Sadako Sasaki and other children affected by the atomic bombing. A single folded crane can also carry a personal message, tucked beside a letter or set on a desk.

Hiroshima City on the Children’s Peace Monument

Printable origami crane instructions

What to fold next

Tried this with paper? Record a fold test