Fold the right corner up and over to the left so it touches the left slanted edge; adjust as you go until the folded flap's top edge is level, then press flat.
Check
The right corner rests on the left slanted edge, and the folded flap's top edge is level, parallel to the bottom edge.
Watch out
If the top edge slants, the corner is too high or too low: slide it up or down the left edge until the top is level.
Lift only the front layer of the point; leave the back layer where it is.
Where it goes
Fold it down along the level line of the rim and tuck it into the pocket, then press flat. The pocket is behind the top slanted flap (the one you just folded over from the left, now slanting up to the right): open that slit at the rim a little with a finger and slide the point down into it.
Hand by hand
Fold the front layer of the point down along the rim line, crease it, then fold it back up.
Find the pocket: the top edge of the top slanted flap (folded over from the left, slanting up to the right) is its opening. Gently separate it from the paper below with a finger.
Slide the point down into that slit, all the way in.
Press flat: the slanted flap now covers the point, so you can't see it from the front.
Check
From the front you see only the two crossed flaps; the front point is hidden in the pocket. The dashed line in the picture is the hidden point.
Watch out
Fold only one layer, and tuck it into the pocket rather than over the outside: afterwards the top slanted flap should cover the point.
Sketch: the rim seen from the side, with the point slid between the top slanted flap and the paper below it.Open step 4 in the folding player
Step 5 Fold the back point behind
What to hold
Pick up the remaining layer of the point.
Where it goes
Fold it down behind along the same rim line, then press flat.
Check
The rim is now a straight top edge, with no points sticking up front or back.
Watch out
This flap folds behind (a mountain fold); don't bring it to the front.